From: Alex Marginean <alexandru.margin...@nxp.com>
On LS1028A, the MAC RX FIFO defaults to the value 2, which is too high
and may lead to RX lock-up under traffic at a rate higher than 6 Gbps.
Set it to 1 instead, as recommended by the hardware design team and by
later versions of the ENETC block guide.
Signed-off-by: Alex Marginean <alexandru.margin...@nxp.com>
Reviewed-by: Claudiu Manoil <claudiu.man...@nxp.com>
Reviewed-by: Jason Liu <jason.hui....@nxp.com>
Signed-off-by: Vladimir Oltean <vladimir.olt...@nxp.com>
---
drivers/net/ethernet/freescale/enetc/enetc_hw.h | 2 ++
drivers/net/ethernet/freescale/enetc/enetc_pf.c | 6 ++++++
2 files changed, 8 insertions(+)
diff --git a/drivers/net/ethernet/freescale/enetc/enetc_hw.h
b/drivers/net/ethernet/freescale/enetc/enetc_hw.h
index de0d20b0f489..00938f7960a4 100644
--- a/drivers/net/ethernet/freescale/enetc/enetc_hw.h
+++ b/drivers/net/ethernet/freescale/enetc/enetc_hw.h
@@ -234,6 +234,8 @@ enum enetc_bdr_type {TX, RX};
#define ENETC_PM0_MAXFRM 0x8014
#define ENETC_SET_TX_MTU(val) ((val) << 16)
#define ENETC_SET_MAXFRM(val) ((val) & 0xffff)
+#define ENETC_PM0_RX_FIFO 0x801c
+#define ENETC_PM0_RX_FIFO_VAL 1
#define ENETC_PM_IMDIO_BASE 0x8030
diff --git a/drivers/net/ethernet/freescale/enetc/enetc_pf.c
b/drivers/net/ethernet/freescale/enetc/enetc_pf.c
index ca02f033bea2..224fc37a6757 100644
--- a/drivers/net/ethernet/freescale/enetc/enetc_pf.c
+++ b/drivers/net/ethernet/freescale/enetc/enetc_pf.c
@@ -490,6 +490,12 @@ static void enetc_configure_port_mac(struct enetc_hw *hw)
enetc_port_wr(hw, ENETC_PM1_CMD_CFG, ENETC_PM0_CMD_PHY_TX_EN |
ENETC_PM0_CMD_TXP | ENETC_PM0_PROMISC);
+
+ /* On LS1028A, the MAC RX FIFO defaults to 2, which is too high
+ * and may lead to RX lock-up under traffic. Set it to 1 instead,
+ * as recommended by the hardware team.
+ */
+ enetc_port_wr(hw, ENETC_PM0_RX_FIFO, ENETC_PM0_RX_FIFO_VAL);
}
static void enetc_mac_config(struct enetc_hw *hw, phy_interface_t phy_mode)
--
2.25.1
