On Sat, Feb 6, 2021 at 7:10 AM Saeed Mahameed <sa...@kernel.org> wrote: > From: Saeed Mahameed <sae...@nvidia.com>
> This series adds the support for VF tunneling. > Vlad Buslov says: > ================= > Implement support for VF tunneling > Abstract > Currently, mlx5 only supports configuration with tunnel endpoint IP address on > uplink representor. Remove implicit and explicit assumptions of tunnel always > being terminated on uplink and implement necessary infrastructure for > configuring tunnels on VF representors and updating rules on such tunnels > according to routing changes. > > SW TC model maybe before SW TC model, you can explain the SW model (TC is a vehicle to implement the SW model). SW model for VST and "classic" v-switch tunnel setup: For example, in VST model, each virtio/vf/sf vport has a vlan such that the v-switch tags packets going out "south" of the vport towards the uplink, untags packets going "north" from the uplink into the vport (and does nothing for east-west traffic). In a similar manner, in "classic" v-switch tunnel setup, each virtio/vf/sf vport is somehow associated with VNI/s marking the tenant/s it belongs to. Same tenant east-west traffic on the host doesn't go through any encap/decap. The v-switch adds the relevant tunnel MD to packets/skbs sent "southward" by the end-point and forwards it to the VTEP which applies encap and sends the packets to the wire. On RX, the VTEP decaps the tunnel info from the packet, adds it as MD to the skb and forwards the packet up into the stack where the vsw hooks it, matches on the MD + inner tuple and then forwards it to the relevant endpoint. HW offloads for VST and "classic" v-switch tunnel setup: more or less straight forward based on the above > From TC perspective VF tunnel configuration requires two rules in both > directions: > > TX rules > > 1. Rule that redirects packets from UL to VF rep that has the tunnel > endpoint IP address: > 2. Rule that decapsulates the tunneled flow and redirects to destination VF > representor: > RX rules > > 1. Rule that encapsulates the tunneled flow and redirects packets from > source VF rep to tunnel device: > 2. Rule that redirects from tunnel device to UL rep: Sorry, I am not managing to follow and catch up a SW model from TC rules.. I think we need these two to begin with: [1] Motivation for enhanced v-switch tunnel setup: [2] SW model for enhanced v-switch tunnel setup: > HW offloads model a clear SW model before HW offloads model..
