On 2/3/21 7:16 PM, Bhaskar Chowdhury wrote: > > > s/initialsation/initialisation/ > s/specifiing/specifying/ > > Signed-off-by: Bhaskar Chowdhury <unixbhas...@gmail.com>
Aside from the Subject: being longer than needed, as Jakub commented, it's fine for me. Thanks. Acked-by: Randy Dunlap <rdun...@infradead.org> > --- > Changes from V2: > Adjust and make changes which are obvious as per Randy's suggestions > > drivers/net/ethernet/i825xx/ether1.c | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) > > diff --git a/drivers/net/ethernet/i825xx/ether1.c > b/drivers/net/ethernet/i825xx/ether1.c > index a0bfb509e002..c612ef526d16 100644 > --- a/drivers/net/ethernet/i825xx/ether1.c > +++ b/drivers/net/ethernet/i825xx/ether1.c > @@ -20,7 +20,7 @@ > * 1.02 RMK 25/05/1997 Added code to restart RU if it goes not > ready > * 1.03 RMK 14/09/1997 Cleaned up the handling of a reset > during the TX interrupt. > * Should prevent lockup. > - * 1.04 RMK 17/09/1997 Added more info when initialsation of chip goes > wrong. > + * 1.04 RMK 17/09/1997 Added more info when initialisation of chip > goes wrong. > * TDR now only reports failure when chip reports > non-zero > * TDR time-distance. > * 1.05 RMK 31/12/1997 Removed calls to dev_tint for 2.1 > @@ -117,7 +117,7 @@ ether1_outw_p (struct net_device *dev, unsigned short > val, int addr, int svflgs) > * Some inline assembler to allow fast transfers on to/off of the card. > * Since this driver depends on some features presented by the ARM > * specific architecture, and that you can't configure this driver > - * without specifiing ARM mode, this is not a problem. > + * without specifying ARM mode, this is not a problem. > * > * This routine is essentially an optimised memcpy from the card's > * onboard RAM to kernel memory. > -- -- ~Randy
