s/initialsation/initialisation/
s/specifiing/specifying/

Signed-off-by: Bhaskar Chowdhury <unixbhas...@gmail.com>
---
 drivers/net/ethernet/i825xx/ether1.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/net/ethernet/i825xx/ether1.c 
b/drivers/net/ethernet/i825xx/ether1.c
index a0bfb509e002..0233fb6e222d 100644
--- a/drivers/net/ethernet/i825xx/ether1.c
+++ b/drivers/net/ethernet/i825xx/ether1.c
@@ -20,7 +20,7 @@
  * 1.02        RMK     25/05/1997      Added code to restart RU if it goes not 
ready
  * 1.03        RMK     14/09/1997      Cleaned up the handling of a reset 
during the TX interrupt.
  *                             Should prevent lockup.
- * 1.04 RMK    17/09/1997      Added more info when initialsation of chip goes 
wrong.
+ * 1.04 RMK    17/09/1997      Added more info when initialisation of chip 
goes wrong.
  *                             TDR now only reports failure when chip reports 
non-zero
  *                             TDR time-distance.
  * 1.05        RMK     31/12/1997      Removed calls to dev_tint for 2.1
@@ -117,7 +117,7 @@ ether1_outw_p (struct net_device *dev, unsigned short val, 
int addr, int svflgs)
  * Some inline assembler to allow fast transfers on to/off of the card.
  * Since this driver depends on some features presented by the ARM
  * specific architecture, and that you can't configure this driver
- * without specifiing ARM mode, this is not a problem.
+ * without specifying ARM mode, this is not a problem.
  *
  * This routine is essentially an optimised memcpy from the card's
  * onboard RAM to kernel memory.
@@ -885,7 +885,7 @@ ether1_recv_done (struct net_device *dev)
                ether1_writew(dev, 0, priv(dev)->rx_tail, rfd_t, rfd_command, 
NORMALIRQS);
                ether1_writew(dev, 0, priv(dev)->rx_tail, rfd_t, rfd_status, 
NORMALIRQS);
                ether1_writew(dev, 0, priv(dev)->rx_tail, rfd_t, rfd_rbdoffset, 
NORMALIRQS);
-
+
                priv(dev)->rx_tail = nexttail;
                priv(dev)->rx_head = ether1_readw(dev, priv(dev)->rx_head, 
rfd_t, rfd_link, NORMALIRQS);
        } while (1);
@@ -1031,7 +1031,7 @@ ether1_probe(struct expansion_card *ec, const struct 
ecard_id *id)

        printk(KERN_INFO "%s: ether1 in slot %d, %pM\n",
                dev->name, ec->slot_no, dev->dev_addr);
-
+
        ecard_set_drvdata(ec, dev);
        return 0;

@@ -1047,7 +1047,7 @@ static void ether1_remove(struct expansion_card *ec)
 {
        struct net_device *dev = ecard_get_drvdata(ec);

-       ecard_set_drvdata(ec, NULL);
+       ecard_set_drvdata(ec, NULL);

        unregister_netdev(dev);
        free_netdev(dev);
--
2.26.2

Reply via email to