From: Henry Tieman <henry.w.tie...@intel.com>
The packet classifier would occasionally misrecognize an IPv6 training
packet when the next protocol field was 0. The correct value for
unspecified protocol is IPPROTO_NONE.
Fixes: 165d80d6adab ("ice: Support IPv6 Flow Director filters")
Signed-off-by: Henry Tieman <henry.w.tie...@intel.com>
Reviewed-by: Paul Menzel <pmen...@molgen.mpg.de>
Tested-by: Tony Brelinski <tonyx.brelin...@intel.com>
Signed-off-by: Tony Nguyen <anthony.l.ngu...@intel.com>
---
drivers/net/ethernet/intel/ice/ice_ethtool_fdir.c | 8 +++++++-
1 file changed, 7 insertions(+), 1 deletion(-)
diff --git a/drivers/net/ethernet/intel/ice/ice_ethtool_fdir.c
b/drivers/net/ethernet/intel/ice/ice_ethtool_fdir.c
index 2d27f66ac853..192729546bbf 100644
--- a/drivers/net/ethernet/intel/ice/ice_ethtool_fdir.c
+++ b/drivers/net/ethernet/intel/ice/ice_ethtool_fdir.c
@@ -1576,7 +1576,13 @@ ice_set_fdir_input_set(struct ice_vsi *vsi, struct
ethtool_rx_flow_spec *fsp,
sizeof(struct in6_addr));
input->ip.v6.l4_header = fsp->h_u.usr_ip6_spec.l4_4_bytes;
input->ip.v6.tc = fsp->h_u.usr_ip6_spec.tclass;
- input->ip.v6.proto = fsp->h_u.usr_ip6_spec.l4_proto;
+
+ /* if no protocol requested, use IPPROTO_NONE */
+ if (!fsp->m_u.usr_ip6_spec.l4_proto)
+ input->ip.v6.proto = IPPROTO_NONE;
+ else
+ input->ip.v6.proto = fsp->h_u.usr_ip6_spec.l4_proto;
+
memcpy(input->mask.v6.dst_ip, fsp->m_u.usr_ip6_spec.ip6dst,
sizeof(struct in6_addr));
memcpy(input->mask.v6.src_ip, fsp->m_u.usr_ip6_spec.ip6src,
--
2.26.2
