On Mon, Nov 16, 2020 at 12:01:55PM -0500, Sven Van Asbroeck wrote:
> From: Sven Van Asbroeck <thesve...@gmail.com>
>
> The code in this driver which parses the devicetree to determine
> the phy/fixed link setup, can be replaced by a single library
> function: of_phy_get_and_connect().
>
> Behaviour is identical, except that the library function will
> complain when 'phy-connection-type' is omitted, instead of
> blindly using PHY_INTERFACE_MODE_NA, which would result in an
> invalid phy configuration.
>
> The library function no longer brings out the exact phy_mode,
> but the driver doesn't need this, because phy_interface_is_rgmii()
> queries the phydev directly. Remove 'phy_mode' from the private
> adapter struct.
>
> While we're here, log info about the attached phy on connect,
> this is useful because the phy type and connection method is now
> fully configurable via the devicetree.
>
> Tested on a lan7430 chip with built-in phy. Verified that adding
> fixed-link/phy-connection-type in the devicetree results in a
> fixed-link setup. Used ethtool to verify that the devicetree
> settings are used.
>
> Tested-by: Sven Van Asbroeck <thesve...@gmail.com> # lan7430
> Signed-off-by: Sven Van Asbroeck <thesve...@gmail.com>
Reviewed-by: Andrew Lunn <and...@lunn.ch>
Andrew
