It was <2020-11-04 śro 03:42>, when Andrew Lunn wrote:
>> +config SPI_AX88796C_COMPRESSION
>> +    bool "SPI transfer compression"
>> +    default n
>> +    depends on SPI_AX88796C
>> +    help
>> +      Say Y here to enable SPI transfer compression. It saves up
>> +      to 24 dummy cycles during each transfer which may noticably
>> +      speed up short transfers. This sets the default value that is
>> +      inherited by network interfecase during probe. It can be
>
> interface
>

Done.

>> +      changed in run time via spi-compression ethtool tunable.
>
> changed _at_ run time...
>

Done.

>> +static int
>> +ax88796c_set_tunable(struct net_device *ndev, const struct ethtool_tunable 
>> *tuna,
>> +                 const void *data)
>> +{
>> +    struct ax88796c_device *ax_local = to_ax88796c_device(ndev);
>> +
>> +    switch (tuna->id) {
>> +    case ETHTOOL_SPI_COMPRESSION:
>> +            if (netif_running(ndev))
>> +                    return -EBUSY;
>> +            ax_local->capabilities &= ~AX_CAP_COMP;
>> +            ax_local->capabilities |= *(u32 *)data ? AX_CAP_COMP : 0;
>
> You should probably validate here that data is 0 or 1. That is what
> ax88796c_get_tunable() will return.
>
> It seems like this controls two hardware bits:
>
> SPICR_RCEN | SPICR_QCEN
>
> Maybe at some point it would make sense to allow these bits to be set
> individually? If you never validate the tunable, you cannot make use
> of other values to control the bits individually.

Good point. What is your recommendation for the userland facing
interface, so that future changes will be least disruptive?

ax_local->capabilities |= ((*(u32 *)data) & SPICR_RCEN) ? AX_CAP_COMP : 0;

or rather

ax_local->capabilities |= ((*(u32 *)data) & (SPICR_RCEN | SPICR_QCEN)) ? 
AX_CAP_COMP : 0;

and possibly in the future (or now) split it into 

ax_local->capabilities |= ((*(u32 *)data) & SPICR_RCEN) ? AX_CAP_COMP_R : 0;
ax_local->capabilities |= ((*(u32 *)data) & SPICR_QCEN) ? AX_CAP_COMP_Q : 0;

(and appropriate masking abve and proper handling in
ax88796c_soft_reset()).

Kind regards
-- 
Łukasz Stelmach
Samsung R&D Institute Poland
Samsung Electronics

Attachment: signature.asc
Description: PGP signature

Reply via email to