On Sun, 2020-10-11 at 22:31 +0300, Petko Manolov wrote: > On 20-10-11 11:33:00, Joe Perches wrote: > > On Sun, 2020-10-11 at 10:59 -0700, Jakub Kicinski wrote: > > > On Sun, 11 Oct 2020 23:00:30 +0530 Anant Thazhemadam wrote: > > > > In set_ethernet_addr(), if get_registers() succeeds, the ethernet > > > > address > > > > that was read must be copied over. Otherwise, a random ethernet address > > > > must be assigned. > > > > > > > > get_registers() returns 0 if successful, and negative error number > > > > otherwise. However, in set_ethernet_addr(), this return value is > > > > incorrectly checked. > > > > > > > > Since this return value will never be equal to sizeof(node_id), a > > > > random MAC address will always be generated and assigned to the > > > > device; even in cases when get_registers() is successful. > > > > > > > > Correctly modifying the condition that checks if get_registers() was > > > > successful or not fixes this problem, and copies the ethernet address > > > > appropriately. > > > > There are many unchecked uses of set_registers and get_registers > > in this file. > > > > If failures are really expected, then it might be better to fix > > them up too. > > Checking the return value of each get/set_registers() is going to be a PITA > and > not very helpful. Doing so when setting the MAC address _does_ make sense as > in > that case it is not a hard error. > > In almost all other occasions if usb_control_msg_send/recv() return an error > i'd > rather dump an error message (from within get/set_registers()) and let the > user > decide whether to get rid of this adapter or start debugging it.
Your code, your choices... Consider using _once or _ratelimited output too.
