Hello, May I know if there are any comments regarding this patch-set before I submit a V3? Just would like to check, since so far the feedback obtained for V1 and V2 has been regarding only the DT documentation.
Thank you, Vineetha > -----Original Message----- > From: [email protected] <[email protected]> On > Behalf Of [email protected] > Sent: Saturday, July 25, 2020 6:18 PM > To: [email protected]; [email protected]; [email protected]; > [email protected] > Cc: [email protected]; [email protected]; Voon, Weifeng > <[email protected]>; Kweh, Hock Leong <[email protected]>; > Ong, Boon Leong <[email protected]> > Subject: [PATCH v2 0/2] Add Ethernet support for Intel Keem Bay SoC > > From: "Vineetha G. Jaya Kumaran" <[email protected]> > > Hello, > > This patch set enables support for Ethernet on the Intel Keem Bay SoC. > The first patch contains the required Device Tree bindings documentation, > while the second patch adds the Intel platform glue layer for the stmmac > device driver. > > This driver was tested on the Keem Bay evaluation module board. > > Thank you. > > Best regards, > Vineetha > > Changes since v1: > -Removed clocks maxItems property from DT bindings documentation > -Removed phy compatible strings from DT bindings documentation > > Rusaimi Amira Ruslan (1): > net: stmmac: Add dwmac-intel-plat for GBE driver > > Vineetha G. Jaya Kumaran (1): > dt-bindings: net: Add bindings for Intel Keem Bay > > .../devicetree/bindings/net/intel,dwmac-plat.yaml | 121 +++++++++++++ > drivers/net/ethernet/stmicro/stmmac/Kconfig | 10 ++ > drivers/net/ethernet/stmicro/stmmac/Makefile | 1 + > .../net/ethernet/stmicro/stmmac/dwmac-intel-plat.c | 191 > +++++++++++++++++++++ > 4 files changed, 323 insertions(+) > create mode 100644 Documentation/devicetree/bindings/net/intel,dwmac- > plat.yaml > create mode 100644 drivers/net/ethernet/stmicro/stmmac/dwmac-intel-plat.c > > -- > 1.9.1
