[PATCH net-next 2/2] net: dsa/b53: use resolved link config in mac_link_up()

[Russell King]

Convert the B53 driver to use the finalised link parameters in
mac_link_up() rather than the parameters in mac_config(). This is
just a matter of moving the call to b53_force_port_config().

Reviewed-by: Florian Fainelli <f.faine...@gmail.com>
Signed-off-by: Russell King <rmk+ker...@armlinux.org.uk>
---
 drivers/net/dsa/b53/b53_common.c | 12 +++---------
 1 file changed, 3 insertions(+), 9 deletions(-)

diff --git a/drivers/net/dsa/b53/b53_common.c b/drivers/net/dsa/b53/b53_common.c
index 8a7fa6092b01..6500179c2ca2 100644
--- a/drivers/net/dsa/b53/b53_common.c
+++ b/drivers/net/dsa/b53/b53_common.c
@@ -1254,17 +1254,9 @@ void b53_phylink_mac_config(struct dsa_switch *ds, int 
port,
 {
        struct b53_device *dev = ds->priv;
 
-       if (mode == MLO_AN_PHY)
+       if (mode == MLO_AN_PHY || mode == MLO_AN_FIXED)
                return;
 
-       if (mode == MLO_AN_FIXED) {
-               b53_force_port_config(dev, port, state->speed,
-                                     state->duplex,
-                                     !!(state->pause & MLO_PAUSE_TX),
-                                     !!(state->pause & MLO_PAUSE_RX));
-               return;
-       }
-
        if ((phy_interface_mode_is_8023z(state->interface) ||
             state->interface == PHY_INTERFACE_MODE_SGMII) &&
             dev->ops->serdes_config)
@@ -1314,6 +1306,8 @@ void b53_phylink_mac_link_up(struct dsa_switch *ds, int 
port,
                return;
 
        if (mode == MLO_AN_FIXED) {
+               b53_force_port_config(dev, port, speed, duplex,
+                                     tx_pause, rx_pause);
                b53_force_link(dev, port, true);
                return;
        }
-- 
2.20.1