On 6/17/2020 1:31 AM, Linus Walleij wrote:
> The code in net/8021q/vlan.c, vlan_device_event() sets
> VLAN 0 for a VLAN-capable ethernet device when it
> comes up.
>
> Since the RTL8366 DSA switches must have a VLAN and
> PVID set up for any packets to come through we have
> already set up default VLAN for each port as part of
> bringing the switch online.
>
> Make sure that setting VLAN 0 has the same effect
> and does not try to actually tell the hardware to use
> VLAN 0 on the port because that will not work.
Why, you are not really describing what happens if VID = 0 is programmed?
It also sounds like you should be setting
configure_vlan_while_not_filtering if you need the switch to be
configured with VLAN awareness no matter whether there is a bridge
configured or not.
--
Florian
