These patches were picked from the following series: https://lore.kernel.org/netdev/1567779344-30965-1-git-send-email-claudiu.man...@nxp.com/ They have never been resent. I've picked them up, addressed Andrews comments, fixed some more bugs and asked Claudiu if I can keep their SOB tags; he agreed. I've tested this on our board which happens to have a bootloader which doesn't do the enetc setup in all cases.
changes since v1: - mdiobus id is '"imdio-%s", dev_name(dev)' because the plain dev_name() is used by the emdio. - use mdiobus_write() instead of imdio->write(imdio, ..), since this is already a full featured mdiobus - set phy_mask to ~0 to avoid scanning the bus - use phy_interface_mode_is_rgmii(phy_mode) to also include the RGMII modes with pad delays. - move enetc_imdio_init() to enetc_pf.c, there shouldn't be any other users, should it? - renamed serdes to SerDes - printing the error code of mdiobus_register() in the error path - call mdiobus_unregister() on _remove() - call devm_mdiobus_free() if mdiobus_register() fails, since an error is not fatal Alex Marginean (1): net: enetc: Use DT protocol information to set up the ports Claudiu Manoil (1): net: enetc: Initialize SerDes for SGMII and SXGMII protocols .../net/ethernet/freescale/enetc/enetc_hw.h | 17 ++ .../net/ethernet/freescale/enetc/enetc_pf.c | 151 +++++++++++++++--- .../net/ethernet/freescale/enetc/enetc_pf.h | 4 + 3 files changed, 148 insertions(+), 24 deletions(-) -- 2.20.1
