If the op-mode for the device is not set in the device tree then set
the strapped op-mode and store it for later configuration.

Signed-off-by: Dan Murphy <dmur...@ti.com>
---
 drivers/net/phy/dp83869.c | 21 ++++++++++++++++++++-
 1 file changed, 20 insertions(+), 1 deletion(-)

diff --git a/drivers/net/phy/dp83869.c b/drivers/net/phy/dp83869.c
index 073a0f7754a5..64fa2d911074 100644
--- a/drivers/net/phy/dp83869.c
+++ b/drivers/net/phy/dp83869.c
@@ -65,6 +65,7 @@
 #define DP83869_RGMII_RX_CLK_DELAY_EN          BIT(0)
 
 /* STRAP_STS1 bits */
+#define DP83869_STRAP_OP_MODE_MASK             GENMASK(2, 0)
 #define DP83869_STRAP_STS1_RESERVED            BIT(11)
 #define DP83869_STRAP_MIRROR_ENABLED           BIT(12)
 
@@ -161,6 +162,20 @@ static int dp83869_config_port_mirroring(struct phy_device 
*phydev)
                                          DP83869_CFG3_PORT_MIRROR_EN);
 }
 
+static int dp83869_set_strapped_mode(struct phy_device *phydev)
+{
+       struct dp83869_private *dp83869 = phydev->priv;
+       u16 val;
+
+       val = phy_read_mmd(phydev, DP83869_DEVADDR, DP83869_STRAP_STS1);
+       if (val < 0)
+               return val;
+
+       dp83869->mode = val & DP83869_STRAP_OP_MODE_MASK;
+
+       return 0;
+}
+
 #ifdef CONFIG_OF_MDIO
 static int dp83869_of_init(struct phy_device *phydev)
 {
@@ -185,6 +200,10 @@ static int dp83869_of_init(struct phy_device *phydev)
                if (dp83869->mode < DP83869_RGMII_COPPER_ETHERNET ||
                    dp83869->mode > DP83869_SGMII_COPPER_ETHERNET)
                        return -EINVAL;
+       } else {
+               ret = dp83869_set_strapped_mode(phydev);
+               if (ret)
+                       return ret;
        }
 
        if (of_property_read_bool(of_node, "ti,max-output-impedance"))
@@ -218,7 +237,7 @@ static int dp83869_of_init(struct phy_device *phydev)
 #else
 static int dp83869_of_init(struct phy_device *phydev)
 {
-       return 0;
+       return dp83869_set_strapped_mode(phydev);
 }
 #endif /* CONFIG_OF_MDIO */
 
-- 
2.26.2

Reply via email to