Hi Steven, I have problems using sky2 v1.10 with with bonding driver (802.3ad), on 'Marvell 88E8053 PCI-E Gigabit Ethernet Controller'. I have attached the full lspci output.
My test was to setup a bond of two physical links (both links same hardware) and ping 192.168.11.10, which is the address of the switch itself. I have tested v1.10 with kernel 2.6.19 and 2.6.16.36 (own backport), which despite the bonding problem runs fine. Both, kernel 2.6.19 and 2.6.16.36 show the same behaviour. The 802.3ad aware switch is a Dell PowerConnect 5324. VLAN is not configured on all switch ports. Another test on a host running kernel 2.6.18.2 with two e1000's bonded runs fine. Using sk98lin (v8.41 & v10.0.4) worked also. The host containing the Yukon-II has a total of 8 NICs, 4 PIC and 4 PCI-E, see attached lspci output. The failed bond was created from two PCI-E interfaces. Find attached a short script which I use to set up the bond on both hosts, also attached is a procfile (/proc/net/bonding/bond0) from the "e1000 host" with a working bond as well as the procfile from the host with the Yukon-II cards. When looking at the working bond I see that both slave interfaces are IFF_UP, the load is shared over both links. When looking at the failing sky2 bond I see that the bond is not IFF_UP, whereas both slave interfaces are IFF_UP. The 802.3ad "partner MAC address" is left all zero's, also both interfaces have different Aggregator IDs (1 & 2). One of the two failing interfaces always has IFF_NOARP set, caused by code calling bond_main.c:bond_set_slave_inactive_flags(). I used both use_carrier=1 (default) as well as miimon=50 without luck. Going through the bonding code, and comparing sky2 source to the e100 code, which I am quite familiar with, I see that sky2 does not use the generic MII interface, which might point in the right direction. I am currently going through the bonding code and try to understand the master <-> slave <-> sky2 interaction, basically this is either through calling the sky2 net_device ops and through the ethtool ops. If you need further info or further testing from my side: i will gladly do that. Besides that, thanks for a great driver! /holger
bonding-prob.tgz
Description: bonding-prob.tgz
