On 08.04.2019 14:12, kavyasree.kotag...@microchip.com wrote: > From: Kavya Sree Kotagiri <kavyasree.kotag...@microchip.com> > > The VSC8514 PHY is a 4-ports PHY that is 10/100/1000BASE-T, 100BASE-FX, > 1000BASE-X, can communicate with the MAC via QSGMII. > The MAC interface protocol for each port within QSGMII can > be either 1000BASE-X or SGMII, if the QSGMII MAC that the VSC8514 is > connecting to supports this functionality. > VSC8514 also supports SGMII MAC-side autonegotiation on each individual > port, downshifting, can set the blinking pattern of each of its 4 LEDs, > SyncE, 1000BASE-T Ring Resiliency as well as HP Auto-MDIX detection. > > This adds support for 10BASE-T, 100BASE-TX, and 1000BASE-T, > QSGMII link with the MAC, downshifting, HP Auto-MDIX detection > and blinking pattern for its 4 LEDs. > > The GPIO register bank is a set of registers that are common to all PHYs > in the package. So any modification in any register of this bank affects > all PHYs of the package. > > If the PHYs haven't been reset before booting the Linux kernel and were > configured to use interrupts for e.g. link status updates, it is > required to clear the interrupts mask register of all PHYs before being > able to use interrupts with any PHY. The first PHY of the package that > will be init will take care of clearing all PHYs interrupts mask > registers. Thus, we need to keep track of the init sequence in the > package, if it's already been done or if it's to be done. > > Most of the init sequence of a PHY of the package is common to all PHYs > in the package, thus we use the SMI broadcast feature which enables us > to propagate a write in one register of one PHY to all PHYs in the same > package. > > Signed-off-by: Kavya Sree Kotagiri <kavyasree.kotag...@microchip.com> > Signed-off-by: Quentin Schulz <quentin.sch...@bootlin.com> > Co-developed-by: Quentin Schulz <quentin.sch...@bootlin.com>
I just got the following: 550 5.1.1 <quentin.sch...@bootlin.com>: Recipient address rejected: User unknown in virtual mailbox table Does the email address need updating?
