On 3/23/2019 8:23 PM, Vladimir Oltean wrote:
> VLAN filtering cannot be properly disabled in SJA1105. So in order to
> emulate the "no VLAN awareness" behavior (not dropping traffic that is
> tagged with a VID that isn't configured on the port), we need to hack
> another switch feature: programmable TPID (which is 0x8100 for 802.1Q).
> We are reprogramming the TPID to a bogus value (ETH_P_EDSA) which leaves
> the switch thinking that all traffic is untagged, and therefore accepts
> it.
>
> Under a vlan_filtering bridge, the proper TPID of ETH_P_8021Q is
> installed again, and the switch starts identifying 802.1Q-tagged
> traffic.
>
> Signed-off-by: Vladimir Oltean <olte...@gmail.com>
> ---
[snip]
> + for (i = 0; i < SJA1105_NUM_PORTS; i++) {
> + struct net_device *bridge_dev;
> +
> + bridge_dev = dsa_to_port(ds, i)->bridge_dev;
> + if (bridge_dev &&
> + bridge_dev != dsa_to_port(ds, port)->bridge_dev &&
> + br_vlan_enabled(bridge_dev) != enabled) {
> + netdev_err(bridge_dev,
> + "VLAN filtering is global to the switch!\n");
> + return -EINVAL;
> + }
We might want to move this to the DSA core at some point, I had some
patches lying around for doing that but got side tracked with adding
management support for b53/bcm_sf2. Not a big problem for now.
Reviewed-by: Florian Fainelli <f.faine...@gmail.com>
--
Florian
