Hi,
Working with iproute2 for a task with Wireshark. I don't see the
command in 'ip' to put an Ethernet port into promiscuous mode. A reply
from the openSuse forum (below) tells me how.
I'm wondering if this should be in the 'MAN ip' page.
Regards,
Bill Flanagan
-------- Forwarded Message --------
Dear konsultor,
tsu2 has just replied to a thread you have subscribed to entitled - LEAP
15 how to set promiscuous mode on eth0? - in the Network/Internet forum
of openSUSE Forums.
This thread is located at:
https://forums.opensuse.org/showthread.php/534881-how-to-set-promiscuous-mode-on-eth0?goto=newpost
Here is the message that has just been posted:
***************
---Quote (Originally by konsultor)---
Thanks, Tsu. Double 'atta boy" for sure.
What I find odd is that neither 'promisc' nor 'promiscuous' appears in
the 'MAN ip" document. Is that a reportable bug?
---End Quote---
MAN authors are typically listed in the document, best to write them
directly.
TSU
***************
There may also be other replies, but you will not receive any more
notifications until you visit the forum again.
All the best,
openSUSE Forums
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Unsubscription information:
To unsubscribe from this thread, please visit this page:
https://forums.opensuse.org/subscription.php?do=removesubscription&type=thread&subscriptionid=189629&auth=887f2c6151997a4244524bdac85ff08b
To unsubscribe from ALL threads, please visit this page:
https://forums.opensuse.org/subscription.php?do=viewsubscription&folderid=all
--
Flanagan Consulting
Creative Network Solutions
From Desktop to Data Center
3800 Concorde Parkway, Suite 1500, Chantilly, Virginia 20151 USA
Ph: +1.703.242.8381 Fx: +1.703.242.8391
www.Flanagan-Consulting.com
Flanagan Consulting is a Service Mark of W. A. Flanagan, Inc.
"Beware of false knowledge; it is more dangerous than ignorance."
--George Bernard Shaw
