Subject: e1000: workaround for the ESB2 NIC RX unit issue
From: Jesse Brandeburg <[EMAIL PROTECTED]>
In rare occasions, ESB2 systems would end up started without the RX
unit being turned on. Add a check that runs post-init to work around this
issue.
Signed-off-by: Jesse Brandeburg <[EMAIL PROTECTED]>
Signed-off-by: Auke Kok <[EMAIL PROTECTED]>
Signed-off-by: Arjan van de Ven <[EMAIL PROTECTED]>
---
drivers/net/e1000/e1000_main.c | 7 +++++++
1 file changed, 7 insertions(+)
Index: linux-2.6/drivers/net/e1000/e1000_main.c
===================================================================
--- linux-2.6.orig/drivers/net/e1000/e1000_main.c
+++ linux-2.6/drivers/net/e1000/e1000_main.c
@@ -2579,6 +2579,13 @@ e1000_watchdog(unsigned long data)
netif_wake_queue(netdev);
mod_timer(&adapter->phy_info_timer, jiffies + 2 * HZ);
adapter->smartspeed = 0;
+ } else {
+ /* make sure the receive unit is started */
+ if (adapter->hw.mac_type == e1000_80003es2lan) {
+ struct e1000_hw *hw = &adapter->hw;
+ uint32_t rctl = E1000_READ_REG(hw, RCTL);
+ E1000_WRITE_REG(hw, RCTL, rctl | E1000_RCTL_EN);
+ }
}
} else {
if (netif_carrier_ok(netdev)) {
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
