On Mon, Jan 28, 2019 at 09:24:09PM +0800, YueHaibing wrote:
> Fix coccinelle warning:
>
> ./drivers/net/phy/mdio_bus.c:51:5-12: ERROR: PTR_ERR applied after
> initialization to constant on line 44
> ./drivers/net/phy/mdio_bus.c:52:5-12: ERROR: PTR_ERR applied after
> initialization to constant on line 44
>
> fix this by using IS_ERR before PTR_ERR
>
> Fixes: bafbdd527d56 ("phylib: Add device reset GPIO support")
> Signed-off-by: YueHaibing <yuehaib...@huawei.com>
> ---
> drivers/net/phy/mdio_bus.c | 13 ++++++++-----
> 1 file changed, 8 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/net/phy/mdio_bus.c b/drivers/net/phy/mdio_bus.c
> index 3d31358..802716a 100644
> --- a/drivers/net/phy/mdio_bus.c
> +++ b/drivers/net/phy/mdio_bus.c
> @@ -42,17 +42,20 @@
> static int mdiobus_register_gpiod(struct mdio_device *mdiodev)
> {
> struct gpio_desc *gpiod = NULL;
> + int ret;
>
Hi YueHaibing
I think i prefer the simpler fix:
static int mdiobus_register_gpiod(struct mdio_device *mdiodev)
{
- struct gpio_desc *gpiod = NULL;
+ struct gpio_desc *gpiod = ERR_PTR(-ENOENT);
Totally untested...
Andrew
> /* Deassert the optional reset signal */
> if (mdiodev->dev.of_node)
> gpiod = fwnode_get_named_gpiod(&mdiodev->dev.of_node->fwnode,
> "reset-gpios", 0, GPIOD_OUT_LOW,
> "PHY reset");
> - if (PTR_ERR(gpiod) == -ENOENT ||
> - PTR_ERR(gpiod) == -ENOSYS)
> - gpiod = NULL;
> - else if (IS_ERR(gpiod))
> - return PTR_ERR(gpiod);
> + if (IS_ERR(gpiod)) {
> + ret = PTR_ERR(gpiod);
> + if (ret == -ENOENT || ret == -ENOSYS)
> + gpiod = NULL;
> + else
> + return ret;
> + }
>
> mdiodev->reset = gpiod;
>
> --
> 2.7.4
>
>
