On Fri, Nov 16, 2018 at 04:28:29PM -0200, Otavio Salvador wrote:
> Hi,
>
> I have a custom design based on Rockchip RV1108 that uses an MSZ8863
> switch running kernel 4.19.
>
> The dts part is as follows:
>
> &gmac {
> pinctrl-names = "default";
> pinctrl-0 = <&rmii_pins>;
> snps,reset-gpio = <&gpio1 RK_PC1 GPIO_ACTIVE_LOW>;
> snps,reset-active-low;
> clock_in_out = "output";
> status = "okay";
> };
>
> RV1108 GMAC is connected to KSZ8863 port 3 and after kernel boots, I
> can put an Ethernet cable from my router to the uplink port of
> KSZ8863, which makes the RV1108 board and a Linux PC connected to the
> other KSZ8863 port to both get IP addresses.
>
> So in this usecase the setup is working fine.
>
> However, if the RV1108 board boots with both Ethernet cables to the
> KSZ8863 switch connected, then the kernel silently hangs.
Hi Otavio
By silently, you mean it prints nothing at all?
I would try building the kernel with all the lock debugging turned
on. That might find something even with your working case, if there is
a potential deadlock.
If the kernel dies very early, you might need to enable "kernel
low-level debugping print and EARLY_PRINTK, in order to see anything.
Andrew
