On 23.08.2018 10:45, Anssi Hannula wrote:
> macb_reset_hw() is called from macb_close() and indirectly from
> macb_open(). macb_reset_hw() zeroes the NCR register, including the MPE
> (Management Port Enable) bit.
> 
> This will prevent accessing any other PHYs for other Ethernet MACs on
> the MDIO bus, which remains registered at macb_reset_hw() time, until
> macb_init_hw() is called from macb_open() which sets the MPE bit again.
> 
> I.e. currently the MDIO bus has a short disruption at open time and is
> disabled at close time until the interface is opened again.
> 
> Fix that by only touching the RE and TE bits when enabling and disabling
> RX/TX.
> 
> v2: Make macb_init_hw() NCR write a single statement.

This usually goes after the tree '-' below.

> 
> Fixes: 6c36a7074436 ("macb: Use generic PHY layer")
> Signed-off-by: Anssi Hannula <anssi.hann...@bitwise.fi>
> ---

Here:

v2: Make macb_init_hw() NCR write a single statement.

Other than this: 

Reviewed-by: Claudiu Beznea <claudiu.bez...@microchip.com>

Checked that link goes up and ping is working on a SAMA5D2 Xplained:

Tested-by: Claudiu Beznea <claudiu.bez...@microchip.com>

>  drivers/net/ethernet/cadence/macb_main.c | 9 ++++++---
>  1 file changed, 6 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/net/ethernet/cadence/macb_main.c 
> b/drivers/net/ethernet/cadence/macb_main.c
> index dc09f9a8a49b..225a7c8bad2d 100644
> --- a/drivers/net/ethernet/cadence/macb_main.c
> +++ b/drivers/net/ethernet/cadence/macb_main.c
> @@ -2028,14 +2028,17 @@ static void macb_reset_hw(struct macb *bp)
>  {
>       struct macb_queue *queue;
>       unsigned int q;
> +     u32 ctrl = macb_readl(bp, NCR);
>  
>       /* Disable RX and TX (XXX: Should we halt the transmission
>        * more gracefully?)
>        */
> -     macb_writel(bp, NCR, 0);
> +     ctrl &= ~(MACB_BIT(RE) | MACB_BIT(TE));
>  
>       /* Clear the stats registers (XXX: Update stats first?) */
> -     macb_writel(bp, NCR, MACB_BIT(CLRSTAT));
> +     ctrl |= MACB_BIT(CLRSTAT);
> +
> +     macb_writel(bp, NCR, ctrl);
>  
>       /* Clear all status flags */
>       macb_writel(bp, TSR, -1);
> @@ -2223,7 +2226,7 @@ static void macb_init_hw(struct macb *bp)
>       }
>  
>       /* Enable TX and RX */
> -     macb_writel(bp, NCR, MACB_BIT(RE) | MACB_BIT(TE) | MACB_BIT(MPE));
> +     macb_writel(bp, NCR, macb_readl(bp, NCR) | MACB_BIT(RE) | MACB_BIT(TE));
>  }
>  
>  /* The hash address register is 64 bits long and takes up two
> 

Reply via email to