I was wondering if anyone has had any issues when trying to force a
BCM5461 phy into 10M/full duplex. I seem to be having an issue in
the two managed switches I've tried this on but autoneg to 10/half.
This causes a problem in that I start seeing a large number of frame
errors.
I believe, but need to double check, that if I leave the BCM5461 in
autoneg, and foce the switch to 10M/full that the BCM5461 will
autoneg at 10M/half duplex.
Just wondering if anyone else has seen similar behavior with this PHY.
thanks
- kumar
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
