From: Sven Eckelmann <s...@narfation.org>
All tools which were known to the batman-adv development team are
supporting the batman-adv netlink interface since a while. Also debugfs is
not supported for batman-adv interfaces in any non-default netns. Thus
disabling CONFIG_BATMAN_ADV_DEBUGFS by default should not cause problems on
most systems. It is still possible to enable it in case it is still
required in a specific setup.
Signed-off-by: Sven Eckelmann <s...@narfation.org>
Signed-off-by: Simon Wunderlich <s...@simonwunderlich.de>
---
net/batman-adv/Kconfig | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/net/batman-adv/Kconfig b/net/batman-adv/Kconfig
index e4e2e02b7380..bee034a95208 100644
--- a/net/batman-adv/Kconfig
+++ b/net/batman-adv/Kconfig
@@ -94,13 +94,13 @@ config BATMAN_ADV_DEBUGFS
bool "batman-adv debugfs entries"
depends on BATMAN_ADV
depends on DEBUG_FS
- default y
+ default n
help
Enable this to export routing related debug tables via debugfs.
The information for each soft-interface and used hard-interface can be
found under batman_adv/
- If unsure, say Y.
+ If unsure, say N.
config BATMAN_ADV_DEBUG
bool "B.A.T.M.A.N. debugging"
--
2.11.0
