[for-next 05/15] net/mlx5: Properly handle a vport destination when setting FTE

[Saeed Mahameed]

From: Shahar Klein <shah...@mellanox.com>

When creating FTE, properly distinguish between destination being vport
or tir. The previous code just worked accidentally b/c of both dest being
in the same offset within a union.

Signed-off-by: Shahar Klein <shah...@mellanox.com>
Reviewed-by: Or Gerlitz <ogerl...@mellanox.com>
Reviewed-by: Roi Dayan <r...@mellanox.com>
Signed-off-by: Saeed Mahameed <sae...@mellanox.com>
---
 drivers/net/ethernet/mellanox/mlx5/core/fs_cmd.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/net/ethernet/mellanox/mlx5/core/fs_cmd.c 
b/drivers/net/ethernet/mellanox/mlx5/core/fs_cmd.c
index ef5afd7c9325..0bfce6a82c91 100644
--- a/drivers/net/ethernet/mellanox/mlx5/core/fs_cmd.c
+++ b/drivers/net/ethernet/mellanox/mlx5/core/fs_cmd.c
@@ -372,6 +372,9 @@ static int mlx5_cmd_set_fte(struct mlx5_core_dev *dev,
                        if (dst->dest_attr.type ==
                            MLX5_FLOW_DESTINATION_TYPE_FLOW_TABLE) {
                                id = dst->dest_attr.ft->id;
+                       } else if (dst->dest_attr.type ==
+                                  MLX5_FLOW_DESTINATION_TYPE_VPORT) {
+                               id = dst->dest_attr.vport_num;
                        } else {
                                id = dst->dest_attr.tir_num;
                        }
-- 
2.17.0