From: Shahar Klein <shah...@mellanox.com>
When mlx5_core is loaded it is expected to sync ports
with all vxlan devices so it can support vxlan encap/decap.
This is done via udp_tunnel_get_rx_info(). Currently this
call is set in mlx5e_nic_enable() and if the netdev is not in
NETREG_REGISTERED state it will not be called.
Normally on load the netdev state is not NETREG_REGISTERED
so udp_tunnel_get_rx_info() will not be called.
Moving udp_tunnel_get_rx_info() to mlx5e_open() so
it will be called on netdev UP event and allow encap/decap.
Fixes: 610e89e05c3f ("net/mlx5e: Don't sync netdev state when not registered")
Signed-off-by: Shahar Klein <shah...@mellanox.com>
Reviewed-by: Roi Dayan <r...@mellanox.com>
Signed-off-by: Saeed Mahameed <sae...@mellanox.com>
---
drivers/net/ethernet/mellanox/mlx5/core/en_main.c | 9 +++------
1 file changed, 3 insertions(+), 6 deletions(-)
diff --git a/drivers/net/ethernet/mellanox/mlx5/core/en_main.c
b/drivers/net/ethernet/mellanox/mlx5/core/en_main.c
index e35859657217..9b4827d36e3e 100644
--- a/drivers/net/ethernet/mellanox/mlx5/core/en_main.c
+++ b/drivers/net/ethernet/mellanox/mlx5/core/en_main.c
@@ -2572,6 +2572,9 @@ int mlx5e_open(struct net_device *netdev)
mlx5_set_port_admin_status(priv->mdev, MLX5_PORT_UP);
mutex_unlock(&priv->state_lock);
+ if (mlx5e_vxlan_allowed(priv->mdev))
+ udp_tunnel_get_rx_info(netdev);
+
return err;
}
@@ -4327,12 +4330,6 @@ static void mlx5e_nic_enable(struct mlx5e_priv *priv)
#ifdef CONFIG_MLX5_CORE_EN_DCB
mlx5e_dcbnl_init_app(priv);
#endif
- /* Device already registered: sync netdev system state */
- if (mlx5e_vxlan_allowed(mdev)) {
- rtnl_lock();
- udp_tunnel_get_rx_info(netdev);
- rtnl_unlock();
- }
queue_work(priv->wq, &priv->set_rx_mode_work);
--
2.14.3
