On Wed, Nov 15, 2017 at 09:00:09PM +0200, Eran Ben Elisha wrote:
> From: Inbar Karmy <inb...@mellanox.com>
>
> This RFC adds support for configuring PFC stall prevention through ethtool.
>
> In the event where the device unexpectedly becomes unresponsive for a long
> period of time, flow control mechanism may propagate pause frames which will
> cause congestion spreading to the entire network.
>
> To prevent this scenario, the device may implement a protection mechanism for
> monitoring and resolving such state. The following patches allow the user to
> control the stall prevention functionality.
>
> PFC stall prevention configuration is done via ethtool -a (pause).
> Two modes are introduced:
> Default - current behavior per driver.
> Auto - protection mechanism controlled automatically by the driver.
Why Auto?
Down in the driver you seem to translate this to a time. And it looks
like your hardware is flexible on that time, it can probably do at
least 8s to 100ms.
Why not specify a time?
What do other vendors support? Time? Number of pause frames sent?
Andrew
