[PATCH v3] ethernet: cavium: octeon: Switch to using netdev_info().

[Steven J. Hill]

Signed-off-by: Steven J. Hill <steven.h...@cavium.com>
Signed-off-by: David Daney <david.da...@cavium.com>
---
 drivers/net/ethernet/cavium/octeon/octeon_mgmt.c | 24 +++++++++++-------------
 1 file changed, 11 insertions(+), 13 deletions(-)

diff --git a/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c 
b/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c
index 2887bca..3f6afb5 100644
--- a/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c
+++ b/drivers/net/ethernet/cavium/octeon/octeon_mgmt.c
@@ -705,14 +705,15 @@ static int octeon_mgmt_ioctl_hwtstamp(struct net_device 
*netdev,
                        u64 clock_comp = (NSEC_PER_SEC << 32) / 
octeon_get_io_clock_rate();
                        if (!ptp.s.ptp_en)
                                cvmx_write_csr(CVMX_MIO_PTP_CLOCK_COMP, 
clock_comp);
-                       pr_info("PTP Clock: Using sclk reference at %lld Hz\n",
-                               (NSEC_PER_SEC << 32) / clock_comp);
+                       netdev_info(netdev,
+                                   "PTP Clock using sclk reference @ %lldHz\n",
+                                   (NSEC_PER_SEC << 32) / clock_comp);
                } else {
                        /* The clock is already programmed to use a GPIO */
                        u64 clock_comp = cvmx_read_csr(CVMX_MIO_PTP_CLOCK_COMP);
-                       pr_info("PTP Clock: Using GPIO %d at %lld Hz\n",
-                               ptp.s.ext_clk_in,
-                               (NSEC_PER_SEC << 32) / clock_comp);
+                       netdev_info(netdev,
+                                   "PTP Clock using GPIO%d @ %lld Hz\n",
+                                   ptp.s.ext_clk_in, (NSEC_PER_SEC << 32) / 
clock_comp);
                }
 
                /* Enable the clock if it wasn't done already */
@@ -926,14 +927,11 @@ static void octeon_mgmt_adjust_link(struct net_device 
*netdev)
        spin_unlock_irqrestore(&p->lock, flags);
 
        if (link_changed != 0) {
-               if (link_changed > 0) {
-                       pr_info("%s: Link is up - %d/%s\n", netdev->name,
-                               phydev->speed,
-                               phydev->duplex == DUPLEX_FULL ?
-                               "Full" : "Half");
-               } else {
-                       pr_info("%s: Link is down\n", netdev->name);
-               }
+               if (link_changed > 0)
+                       netdev_info(netdev, "Link is up - %d/%s\n",
+                                   phydev->speed, phydev->duplex == 
DUPLEX_FULL ? "Full" : "Half");
+               else
+                       netdev_info(netdev, "Link is down\n");
        }
 }
 
-- 
2.1.4