An interrupt-names property can be used in the PPv2 port description
bindings when more than a single interrupt (for rx) is used. Document
this new optional property.
Signed-off-by: Antoine Tenart <antoine.ten...@free-electrons.com>
---
Documentation/devicetree/bindings/net/marvell-pp2.txt | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/marvell-pp2.txt
b/Documentation/devicetree/bindings/net/marvell-pp2.txt
index 18ec66e51b0a..553aadceeeee 100644
--- a/Documentation/devicetree/bindings/net/marvell-pp2.txt
+++ b/Documentation/devicetree/bindings/net/marvell-pp2.txt
@@ -42,6 +42,9 @@ Optional properties (port):
- phy: a phandle to a phy node defining the PHY address (as the reg
property, a single integer).
- marvell,system-controller: a phandle to the system controller.
+- interrupt-names: if more than a single interrupt for rx is given, must
+ be the name associated to the interrupts listed. Valid
+ names are: "rx-shared", "link".
Example for marvell,armada-375-pp2:
@@ -82,18 +85,21 @@ cpm_ethernet: ethernet@0 {
eth0: eth0 {
interrupts = <GIC_SPI 37 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "rx-shared";
port-id = <0>;
gop-port-id = <0>;
};
eth1: eth1 {
interrupts = <GIC_SPI 38 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "rx-shared";
port-id = <1>;
gop-port-id = <2>;
};
eth2: eth2 {
interrupts = <GIC_SPI 39 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "rx-shared";
port-id = <2>;
gop-port-id = <3>;
};
--
2.13.3
