[net-next 14/15] ixgbe: add missing configuration for rate select 1

[Jeff Kirsher]

From: Emil Tantilov <emil.s.tanti...@intel.com>

Add RS1 configuration to ixgbe_set_soft_rate_select_speed()

Signed-off-by: Emil Tantilov <emil.s.tanti...@intel.com>
Tested-by: Andrew Bowers <andrewx.bow...@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirs...@intel.com>
---
 drivers/net/ethernet/intel/ixgbe/ixgbe_common.c | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)

diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c 
b/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c
index 7af85f505bad..4e35e7017f3d 100644
--- a/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c
+++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c
@@ -4278,4 +4278,23 @@ void ixgbe_set_soft_rate_select_speed(struct ixgbe_hw 
*hw,
                hw_dbg(hw, "Failed to write Rx Rate Select RS0\n");
                return;
        }
+
+       /* Set RS1 */
+       status = hw->phy.ops.read_i2c_byte(hw, IXGBE_SFF_SFF_8472_ESCB,
+                                          IXGBE_I2C_EEPROM_DEV_ADDR2,
+                                          &eeprom_data);
+       if (status) {
+               hw_dbg(hw, "Failed to read Rx Rate Select RS1\n");
+               return;
+       }
+
+       eeprom_data = (eeprom_data & ~IXGBE_SFF_SOFT_RS_SELECT_MASK) | rs;
+
+       status = hw->phy.ops.write_i2c_byte(hw, IXGBE_SFF_SFF_8472_ESCB,
+                                           IXGBE_I2C_EEPROM_DEV_ADDR2,
+                                           eeprom_data);
+       if (status) {
+               hw_dbg(hw, "Failed to write Rx Rate Select RS1\n");
+               return;
+       }
 }
-- 
2.12.2