On Fri, May 19, 2017 at 06:57:46PM -0700, Pravin Shelar wrote:
> On Thu, May 18, 2017 at 12:59 PM, Eric Garver <e...@erig.me> wrote:
> > CSMU6_RX is relevant for collect_metadata as well. As such leave it
> > outside of the dev's IPv4/IPv6 checks.
> >
> Can you explain it bit? is this flag used with ipv4 tunnels?
It's used with collect_metadata as both ipv4 and ipv6 sockets will be
created.
openvswitch recently gained support for creating tunnels with rtnetlink.
It sets COLLECT_METADATA and CSUM6_RX. After create, it does a get to
verify the device got created with all the requested configuration. The
verify was failing due to CSUM6_RX not being returned.
Since ip_tunnel_info_af() defaults to returning AF_INET, we fall into
the IPv4 case and CSUM6_RX is never returned. Other relevant areas that
call ip_tunnel_info_af() do so using the info from the skb, not the
geneve_dev.
I hope that made it clear. Thanks for taking a look.
Eric.
> > Fixes: 9b4437a5b870 ("geneve: Unify LWT and netdev handling.")
> > Signed-off-by: Eric Garver <e...@erig.me>
> > ---
> > drivers/net/geneve.c | 8 ++++----
> > 1 file changed, 4 insertions(+), 4 deletions(-)
> >
> > diff --git a/drivers/net/geneve.c b/drivers/net/geneve.c
> > index dec5d563ab19..f557d1dc3f9b 100644
> > --- a/drivers/net/geneve.c
> > +++ b/drivers/net/geneve.c
> > @@ -1311,13 +1311,13 @@ static int geneve_fill_info(struct sk_buff *skb,
> > const struct net_device *dev)
> > if (nla_put_u8(skb, IFLA_GENEVE_UDP_ZERO_CSUM6_TX,
> > !(info->key.tun_flags & TUNNEL_CSUM)))
> > goto nla_put_failure;
> > -
> > - if (nla_put_u8(skb, IFLA_GENEVE_UDP_ZERO_CSUM6_RX,
> > - !geneve->use_udp6_rx_checksums))
> > - goto nla_put_failure;
> > #endif
> > }
> >
> > + if (nla_put_u8(skb, IFLA_GENEVE_UDP_ZERO_CSUM6_RX,
> > + !geneve->use_udp6_rx_checksums))
> > + goto nla_put_failure;
> > +
> > if (nla_put_u8(skb, IFLA_GENEVE_TTL, info->key.ttl) ||
> > nla_put_u8(skb, IFLA_GENEVE_TOS, info->key.tos) ||
> > nla_put_be32(skb, IFLA_GENEVE_LABEL, info->key.label))
> > --
> > 2.12.0
> >
