Hello!

On 04/07/2017 05:30 PM, Niklas Cassel wrote:

From: Niklas Cassel <niklas.cas...@axis.com>

The hardware has a LPI interrupt.
There is already code in the stmmac driver to parse and handle the
interrupt. However, this information was missing from the DT binding.

Signed-off-by: Niklas Cassel <niklas.cas...@axis.com>
---
 Documentation/devicetree/bindings/net/stmmac.txt | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/Documentation/devicetree/bindings/net/stmmac.txt 
b/Documentation/devicetree/bindings/net/stmmac.txt
index f652b0c384ce..8977abc266ac 100644
--- a/Documentation/devicetree/bindings/net/stmmac.txt
+++ b/Documentation/devicetree/bindings/net/stmmac.txt
@@ -8,8 +8,8 @@ Required properties:
   that services interrupts for this device
 - interrupts: Should contain the STMMAC interrupts
 - interrupt-names: Should contain the interrupt names "macirq"
-  "eth_wake_irq" if this interrupt is supported in the "interrupts"
-  property
+  "eth_wake_irq" if this interrupt is supported in the "interrupts property

   Missed closing quote?

+  "eth_lpi" if this interrupt is supported in the "interrupts" property
 - phy-mode: See ethernet.txt file in the same directory.
 - snps,reset-gpio      gpio number for phy reset.
 - snps,reset-active-low boolean flag to indicate if phy reset is active low.
[...]

MBR, Sergei

Reply via email to