On Tue, 2017-03-14 at 00:11 +0100, Andrew Lunn wrote:
> > +static int
> > +mt7530_setup(struct dsa_switch *ds)
> > +{
> > + struct mt7530_priv *priv = ds->priv;
> > + int ret, i, phy_mode;
> > + u8 cpup_mask = 0;
> > + u32 id, val;
> > + struct regmap *regmap;
> > +
> > + /* Make sure that cpu port specfied on the dt is appropriate */
> > + if (!dsa_is_cpu_port(ds, MT7530_CPU_PORT)) {
> > + dev_err(priv->dev, "port not matched with the CPU port\n");
> > + return -EINVAL;
> > + }
> > +
> > + regmap = devm_regmap_init(ds->dev, NULL, priv,
> > + &mt7530_regmap_config);
> > + if (IS_ERR(regmap))
> > + dev_warn(priv->dev, "phy regmap initialization failed");
> > +
> > + phy_mode = of_get_phy_mode(ds->ports[ds->dst->cpu_port].dn);
> > + if (phy_mode < 0) {
> > + dev_err(priv->dev, "Can't find phy-mode for master device\n");
> > + return phy_mode;
> > + }
> > + dev_info(priv->dev, "phy-mode for master device = %x\n", phy_mode);
>
> Hi Sean
>
> It is not documented in the binding that a phy-mode is mandatory for
> the cpu port.
>
> Andrew
Hi Andrew,
thanks for your reviewing. I'll also add the missing part into the next
one.
Sean
