From: Christian Lamparter <chunk...@googlemail.com> Date: Mon, 27 Feb 2017 20:42:15 +0100
> On Wednesday, February 22, 2017 3:37:35 PM CET David Miller wrote: >> From: Christian Lamparter <chunk...@googlemail.com> >> Date: Mon, 20 Feb 2017 20:10:58 +0100 >> >> > This patch adds glue-code that allows the EMAC driver to interface >> > with the existing dt-supported PHYs in drivers/net/phy. >> > >> > Because currently, the emac driver maintains a small library of >> > supported phys for in a private phy.c file located in the drivers >> > directory. >> > >> > The support is limited to mostly single ethernet transceiver like the: >> > CIS8201, BCM5248, ET1011C, Marvell 88E1111 and 88E1112, AR8035. >> > >> > However, routers like the Netgear WNDR4700 and Cisco Meraki MX60(W) >> > have a 5-port switch (AR8327N) attached to the EMAC. The switch chip >> > is supported by the qca8k mdio driver, which uses the generic phy >> > library. Another reason is that PHYLIB also supports the BCM54610, >> > which was used for the Western Digital My Book Live. >> > >> > This will now also make EMAC select PHYLIB. >> > >> > Signed-off-by: Christian Lamparter <chunk...@googlemail.com> >> >> Applied, thanks. >> > Thanks David. > > I noticed that the DT Documentation patch: > "[v1,1/2] dt: emac: document device-tree based phy discovery and setup" > is still pending with "Changes Requested": > <https://patchwork.ozlabs.org/patch/729658/> > > I think this is because of Florian's comment on patch: > "[v1,2/2] net: emac: add support for device-tree based PHY discovery and > setup" > If so, can you please queue this documentation update patch for -next? > (I haven't received any comments or complains. If necessary, I can also > resent it.) Please resend.
