Hi,
----- On Feb 13, 2017, at 12:16 PM, pablo pa...@netfilter.org wrote:
> On Mon, Feb 13, 2017 at 10:25:19AM +0100, Andreas Schultz wrote:
>> Hi,
>>
>> I'm a bit late to comment, but maybe you can consider an additional
>> change for v2...
>>
>> ----- On Feb 3, 2017, at 10:12 AM, Jonas Bonn jo...@southpole.se wrote:
>>
>> > The GTP-tunnel driver is explicitly GGSN-side as it searches for PDP
>> > contexts based on the incoming packets _destination_ address. If we
>> > want to write an SGSN, then we want to be idenityfing PDP contexts
>> > based on _source_ address.
>> >
>> > This patch adds a "flags" argument at GTP-link creation time to specify
>> > whether we are on the GGSN or SGSN side of the tunnel; this flag is then
>> > used to determine which part of the IP packet to use in determining
>> > the PDP context.
>> >
>> > Signed-off-by: Jonas Bonn <jo...@southpole.se>
>> > ---
>> >
>> > drivers/net/gtp.c | 43
>> > ++++++++++++++++++++++++++++++++-----------
>> > include/uapi/linux/gtp.h | 2 +-
>> > include/uapi/linux/if_link.h | 5 +++++
>> > 3 files changed, 38 insertions(+), 12 deletions(-)
>> >
>> > diff --git a/drivers/net/gtp.c b/drivers/net/gtp.c
>> > index 50349a9..1bbac69 100644
>> > --- a/drivers/net/gtp.c
>> > +++ b/drivers/net/gtp.c
>> > @@ -72,6 +72,7 @@ struct gtp_dev {
>> > struct net *net;
>> > struct net_device *dev;
>> >
>> > + unsigned int flags;
>>
>> This should IMHO not go into the gtp_dev, the right place
>> is the PDP context.
>
> So you want to allow mixed configurations where some PDP ctx may be in
> SGSN mode while others in GGSN.
>
> This doesn't make any sense to me. On top of this, don't forget this
> is just for testing, so I don't see any valid usecase for such a fine
> grain thing.
You are right, running such a configuration does not make sense.
However, when I wrote this the PDP context looked like the most
sensible palace to me.
Anyhow, thinking about this again, I think that integrating that flag
in a rewrite of the validation logic in the Rx path make more sense.
Currently we validate the MS as soon as we have found the PDP context.
This should be delayed a bit and the validation should happen after
pulling the GTP header and right before injecting the payload into
the net device. The flag would then indeed go into the gtp_dev.
Andreas
