Hi Marcin,
On Thu, 1 Dec 2016 12:48:39 +0100 Marcin Wojtas wrote:
> Hi Jisheng,
>
> Which baseline do you use?
>
> It took me really lot of time to catch why RX broke after rebase from
> LKv4.1 to LKv4.4. Between those two, in commit:
> 97303480753e ("arm64: Increase the max granular size")
> L1_CACHE_BYTES for all ARMv8 platforms was increased to 128B and so
> did NET_SKB_PAD.
>
> And 128 is more than the maximum that can fit into packet offset
> [11:8]@0x1400. In such case this correction is needed. Did it answer
> your doubts?
That's key! Thanks a lot. In my repo, we don't have commit 97303480753e
("arm64: Increase the max granular size")
I think it would be great if this information can be added into the commit
msg.
IIRC, arm64 maintainers considered to let L1_CACHE_BYTES the _minimum_ of
cache line sizes of arm64. If that's implemented and merged, then we can
revert this patch later.
Thanks,
Jisheng
>
> Best regards,
> Marcin
>
>
>
> 2016-12-01 12:26 GMT+01:00 Jisheng Zhang <jszh...@marvell.com>:
> > Hi Gregory, Marcin,
> >
> > On Wed, 30 Nov 2016 22:42:49 +0100 Gregory CLEMENT wrote:
> >
> >> From: Marcin Wojtas <m...@semihalf.com>
> >>
> >> Prepare the mvneta driver in order to be usable on the 64 bits platform
> >> such as the Armada 3700.
> >>
> >> [gregory.clem...@free-electrons.com]: this patch was extract from a larger
> >> one to ease review and maintenance.
> >>
> >> Signed-off-by: Marcin Wojtas <m...@semihalf.com>
> >> Signed-off-by: Gregory CLEMENT <gregory.clem...@free-electrons.com>
> >> ---
> >> drivers/net/ethernet/marvell/mvneta.c | 17 ++++++++++++++++-
> >> 1 file changed, 16 insertions(+), 1 deletion(-)
> >>
> >> diff --git a/drivers/net/ethernet/marvell/mvneta.c
> >> b/drivers/net/ethernet/marvell/mvneta.c
> >> index 92b9af14c352..8ef03fb69bcd 100644
> >> --- a/drivers/net/ethernet/marvell/mvneta.c
> >> +++ b/drivers/net/ethernet/marvell/mvneta.c
> >> @@ -296,6 +296,12 @@
> >> /* descriptor aligned size */
> >> #define MVNETA_DESC_ALIGNED_SIZE 32
> >>
> >> +/* Number of bytes to be taken into account by HW when putting incoming
> >> data
> >> + * to the buffers. It is needed in case NET_SKB_PAD exceeds maximum packet
> >> + * offset supported in MVNETA_RXQ_CONFIG_REG(q) registers.
> >
> > We also brought up this driver on 64bit platforms, we doesn't have this
> > patch. Maybe I'm wrong, I'm trying to understand why we need this
> > modification. Let's assume the NET_SKB_PAD is 64B, we call
> > mvneta_rxq_offset_set(pp, rxq, 64),
> >
> > {
> > u32 val;
> >
> > val = mvreg_read(pp, MVNETA_RXQ_CONFIG_REG(rxq->id));
> > val &= ~MVNETA_RXQ_PKT_OFFSET_ALL_MASK;
> >
> > /* Offset is in */
> > val |= MVNETA_RXQ_PKT_OFFSET_MASK(offset >> 3);
> > // then this will be "val |= 8;" it doesn't exceeds the max offset of
> > MVNETA_RXQ_CONFIG_REG(q) register.
> >
> > Could you please kindly point out where I am wrong?
> >
> >> + */
> >> +#define MVNETA_RX_PKT_OFFSET_CORRECTION 64
> >> +
> >> #define MVNETA_RX_PKT_SIZE(mtu) \
> >> ALIGN((mtu) + MVNETA_MH_SIZE + MVNETA_VLAN_TAG_LEN + \
> >> ETH_HLEN + ETH_FCS_LEN, \
> >> @@ -416,6 +422,7 @@ struct mvneta_port {
> >> u64 ethtool_stats[ARRAY_SIZE(mvneta_statistics)];
> >>
> >> u32 indir[MVNETA_RSS_LU_TABLE_SIZE];
> >> + u16 rx_offset_correction;
> >> };
> >>
> >> /* The mvneta_tx_desc and mvneta_rx_desc structures describe the
> >> @@ -1807,6 +1814,7 @@ static int mvneta_rx_refill(struct mvneta_port *pp,
> >> return -ENOMEM;
> >> }
> >>
> >> + phys_addr += pp->rx_offset_correction;
> >> mvneta_rx_desc_fill(rx_desc, phys_addr, data, rxq);
> >> return 0;
> >> }
> >> @@ -2782,7 +2790,7 @@ static int mvneta_rxq_init(struct mvneta_port *pp,
> >> mvreg_write(pp, MVNETA_RXQ_SIZE_REG(rxq->id), rxq->size);
> >>
> >> /* Set Offset */
> >> - mvneta_rxq_offset_set(pp, rxq, NET_SKB_PAD);
> >> + mvneta_rxq_offset_set(pp, rxq, NET_SKB_PAD -
> >> pp->rx_offset_correction);
> >>
> >> /* Set coalescing pkts and time */
> >> mvneta_rx_pkts_coal_set(pp, rxq, rxq->pkts_coal);
> >> @@ -4033,6 +4041,13 @@ static int mvneta_probe(struct platform_device
> >> *pdev)
> >>
> >> pp->rxq_def = rxq_def;
> >>
> >> + /* Set RX packet offset correction for platforms, whose
> >> + * NET_SKB_PAD, exceeds 64B. It should be 64B for 64-bit
> >> + * platforms and 0B for 32-bit ones.
> >
> > Even we need this patch, I'm not sure this last comment is correct or not.
> > NET_SKB_PAD is defined as:
> >
> > #define NET_SKB_PAD max(32, L1_CACHE_BYTES)
> >
> > we have 64B cacheline 32bit platforms, on this platforms, the NET_SKB_PAD
> > should be 64B as well.
> >
> > Thanks,
> > Jisheng
