[PATCH v2 1/1] net: macb: ensure ordering write to re-enable RX smoothly

[Zumeng Chen]

When a hardware issue happened as described by inline comments, the register
write pattern looks like the following:

<write ~MACB_BIT(RE)>
+ wmb();
<write MACB_BIT(RE)>

There might be a memory barrier between these two write operations, so add wmb
to ensure an flip from 0 to 1 for NCR.

Signed-off-by: Zumeng Chen <zumeng.c...@windriver.com>
---

V2 changes:

Add the same wmb for at91ether as well based on reviewer's suggestion.

Cheers,
 drivers/net/ethernet/cadence/macb.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/net/ethernet/cadence/macb.c 
b/drivers/net/ethernet/cadence/macb.c
index 533653b..6d7cfa7 100644
--- a/drivers/net/ethernet/cadence/macb.c
+++ b/drivers/net/ethernet/cadence/macb.c
@@ -1156,6 +1156,7 @@ static irqreturn_t macb_interrupt(int irq, void *dev_id)
                if (status & MACB_BIT(RXUBR)) {
                        ctrl = macb_readl(bp, NCR);
                        macb_writel(bp, NCR, ctrl & ~MACB_BIT(RE));
+                       wmb();
                        macb_writel(bp, NCR, ctrl | MACB_BIT(RE));
 
                        if (bp->caps & MACB_CAPS_ISR_CLEAR_ON_WRITE)
@@ -2770,6 +2771,7 @@ static irqreturn_t at91ether_interrupt(int irq, void 
*dev_id)
        if (intstatus & MACB_BIT(RXUBR)) {
                ctl = macb_readl(lp, NCR);
                macb_writel(lp, NCR, ctl & ~MACB_BIT(RE));
+               wmb();
                macb_writel(lp, NCR, ctl | MACB_BIT(RE));
        }
 
-- 
2.4.11