Subject: [RFT 5/5] sky2: stop/start hardware idle timer on suspend/resume
The resume bug was cause not by an early interrupt but because
the idle timeout was not being stopped on suspend. Also disable hardware
IRQ's on suspend. Will need to revisit this with hotplug?
Signed-off-by: Stephen Hemminger <[EMAIL PROTECTED]>
--- test.orig/drivers/net/sky2.c
+++ test/drivers/net/sky2.c
@@ -2161,6 +2161,13 @@ static void sky2_descriptor_error(struct
/* If idle then force a fake soft NAPI poll once a second
* to work around cases where sharing an edge triggered interrupt.
*/
+static inline void sky2_idle_start(struct sky2_hw *hw)
+{
+ if (idle_timeout > 0)
+ mod_timer(&hw->idle_timer,
+ jiffies + msecs_to_jiffies(idle_timeout));
+}
+
static void sky2_idle(unsigned long arg)
{
struct sky2_hw *hw = (struct sky2_hw *) arg;
@@ -3350,9 +3357,7 @@ static int __devinit sky2_probe(struct p
sky2_write32(hw, B0_IMSK, Y2_IS_BASE);
setup_timer(&hw->idle_timer, sky2_idle, (unsigned long) hw);
- if (idle_timeout > 0)
- mod_timer(&hw->idle_timer,
- jiffies + msecs_to_jiffies(idle_timeout));
+ sky2_idle_start(hw);
pci_set_drvdata(pdev, hw);
@@ -3430,6 +3435,8 @@ static int sky2_suspend(struct pci_dev *
if (!(pstate == PCI_D3hot || pstate == PCI_D3cold))
return -EINVAL;
+ del_timer_sync(&hw->idle_timer);
+
for (i = 0; i < hw->ports; i++) {
struct net_device *dev = hw->dev[i];
@@ -3472,10 +3479,12 @@ static int sky2_resume(struct pci_dev *p
printk(KERN_ERR PFX "%s: could not up: %d\n",
dev->name, err);
dev_close(dev);
- break;
+ goto out;
}
}
}
+
+ sky2_idle_start(hw);
out:
return err;
}
--
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
