On 31/10/2016 17:28, Mason wrote:
> On 31/10/2016 16:53, Andrew Lunn wrote:
>
>>> I'll add a log for the request_irq call.
>>
>> And take a look at /proc/interrupts
>
> You're right, there does seem to be something wrong with the interrupts.
Having fixed that, I'm still unable to ping a box on the same
ethernet segment... Still investigating.
I think I may have spotted a potential issue in the Atheros driver.
if (phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID ||
phydev->interface == PHY_INTERFACE_MODE_RGMII_ID) {
ret = at803x_enable_rx_delay(phydev);
if (ret < 0)
return ret;
}
Looking at this code, one might believe that "rgmii rx clock delay"
is only enabled when the user requests it (through DT).
http://www.redeszone.net/app/uploads/2014/04/AR8035.pdf
cf. PDF page 48
*However* this bit is set to 1 at reset (both HW and SW resets).
Thus, "rgmii rx clock delay" is always enabled, whether the user
requests it or not.
Could someone knowledgeable comment on the expected behavior of
enabling rgmii rx (and tx) clock delay?
https://en.wikipedia.org/wiki/Media-independent_interface#Reduced_gigabit_media-independent_interface
Regards.
