Marvell 88E1111 currently uses the generic marvell config ANEG function.
This function has a sequence accessing Page 5 and Register 31,
both of which are not defined or reserved for this PHY.
Hence this patch adds a new config ANEG function for Marvell 88E1111
without these erroneous accesses.
Signed-off-by: Harini Katakam <hari...@xilinx.com>
---
drivers/net/phy/marvell.c | 44 +++++++++++++++++++++++++++++++++++++++++++-
1 file changed, 43 insertions(+), 1 deletion(-)
diff --git a/drivers/net/phy/marvell.c b/drivers/net/phy/marvell.c
index 280e879..783d0ca 100644
--- a/drivers/net/phy/marvell.c
+++ b/drivers/net/phy/marvell.c
@@ -285,6 +285,48 @@ static int marvell_config_aneg(struct phy_device *phydev)
return 0;
}
+static int m88e1111_config_aneg(struct phy_device *phydev)
+{
+ int err;
+
+ /* The Marvell PHY has an errata which requires
+ * that certain registers get written in order
+ * to restart autonegotiation
+ */
+ err = phy_write(phydev, MII_BMCR, BMCR_RESET);
+
+ err = marvell_set_polarity(phydev, phydev->mdix);
+ if (err < 0)
+ return err;
+
+ err = phy_write(phydev, MII_M1111_PHY_LED_CONTROL,
+ MII_M1111_PHY_LED_DIRECT);
+ if (err < 0)
+ return err;
+
+ err = genphy_config_aneg(phydev);
+ if (err < 0)
+ return err;
+
+ if (phydev->autoneg != AUTONEG_ENABLE) {
+ int bmcr;
+
+ /* A write to speed/duplex bits (that is performed by
+ * genphy_config_aneg() call above) must be followed by
+ * a software reset. Otherwise, the write has no effect.
+ */
+ bmcr = phy_read(phydev, MII_BMCR);
+ if (bmcr < 0)
+ return bmcr;
+
+ err = phy_write(phydev, MII_BMCR, bmcr | BMCR_RESET);
+ if (err < 0)
+ return err;
+ }
+
+ return 0;
+}
+
#ifdef CONFIG_OF_MDIO
/*
* Set and/or override some configuration registers based on the
@@ -1161,7 +1203,7 @@ static struct phy_driver marvell_drivers[] = {
.flags = PHY_HAS_INTERRUPT,
.probe = marvell_probe,
.config_init = &m88e1111_config_init,
- .config_aneg = &marvell_config_aneg,
+ .config_aneg = &m88e1111_config_aneg,
.read_status = &marvell_read_status,
.ack_interrupt = &marvell_ack_interrupt,
.config_intr = &marvell_config_intr,
--
1.7.9.5
