On 2016/6/13 21:32, Andrew Lunn wrote:
> On Mon, Jun 13, 2016 at 02:07:54PM +0800, Dongpo Li wrote:
>> This patch adds a separate driver for the MDIO interface of the
>> Hisilicon Fast Ethernet MAC.
>>
>> Reviewed-by: Jiancheng Xue <xuejianch...@hisilicon.com>
>> Signed-off-by: Dongpo Li <lidon...@hisilicon.com>
>> ---
>>  .../bindings/net/hisilicon-femac-mdio.txt          |  22 +++
>>  drivers/net/phy/Kconfig                            |   8 +
>>  drivers/net/phy/Makefile                           |   1 +
>>  drivers/net/phy/mdio-hisi-femac.c                  | 165 
>> +++++++++++++++++++++
>>  4 files changed, 196 insertions(+)
>>  create mode 100644 
>> Documentation/devicetree/bindings/net/hisilicon-femac-mdio.txt
>>  create mode 100644 drivers/net/phy/mdio-hisi-femac.c

[...]
>> +
> 
> Hi Dongpo
> 
> Overall this looks good. Just some minor comments
> 
>> +static int hisi_femac_mdio_wait_ready(struct mii_bus *bus)
>> +{
>> +    struct hisi_femac_mdio_data *data = bus->priv;
> 
> You could just pass data here. Your read and write functions already
> have it.
> 
Thank you, I will fix it in next patch version.

>> +    data->clk = devm_clk_get(&pdev->dev, NULL);
>> +    if (IS_ERR(data->clk)) {
>> +            ret = -ENODEV;
>> +            goto err_out_free_mdiobus;
>> +    }
> 
> Return the error which devm_clk_get() gives you.
> 
ok, I will fix it.

>> +
>> +    ret = clk_prepare_enable(data->clk);
>> +    if (ret)
>> +            goto err_out_free_mdiobus;
>> +
>> +    ret = of_mdiobus_register(bus, np);
>> +    if (ret)
>> +            goto err_out_free_mdiobus;
> 
> You leave the clock prepared and enabled on error.
> 
ok, I will fix it.

>     Andrew
> 
> .
> 

Reply via email to