Hello,
On Sun, 12 Jun 2016, Hannes Frederic Sowa wrote:
> On Sun, Jun 12, 2016, at 02:09, Julian Anastasov wrote:
> >
> > Well, may be the confusion comes from commit 89aef8921bfb
> > ("ipv4: Delete routing cache.") where the 'tos &= IPTOS_RT_MASK;'
> > line is lost from ip_route_input_common. I think, we should
> > add it back, so that we can properly match input routes with rules
> > that specify tos value. Old kernels didn't stored ECN bits in
> > flowi4_tos in the input path, so we should do the same.
>
> I would love to have done that but was fearing problems with user space
> compatibility. Also IPTOS_RT_MASK is not enough for filtering, we need
> to check for the whole INET_ECN_MASK.
I checked even 2.4.33 for reference. Nobody sets bit 1
in key->tos but using IPTOS_TOS_MASK on configuration allows
rules with 'tos 2'. I guess, in this case such rule can not be
matched. And the TOS matching was used only under
CONFIG_IP_ROUTE_TOS, so the ip rules were supposed to match only
bits 2..4, not full TOS values.
> > > + INET_ECN_ignore(r->tos) != INET_ECN_ignore(fl4->flowi4_tos))
> > > return 0;
> >
> > fib4_rule_configure already rejects ECN bits in r->tos,
> > so no need to filter them again in fast path.
>
> The problem is that IPTOS_TOS_MASK is just the masking of the 0x1 bit,
> not both ECN bits. Thi stems from the pre-DSCP time where it was
> forbidden to use bit 0x1 in TOS.
I see, I didn't noticed it. If we decide to reject
rules with tos 2 we can break scripts. May be we should just
filter it:
if (r->tos && ((r->tos & IPTOS_RT_MASK) != fl4->flowi4_tos))
This will allow the hidden feature 'ip rule add tos 2' to
match properly bits2..4 == 0 :) But may be we should not spend
extra cycles in fast path for such feature. As nobody complained
for problems with 3.6+, it seems match by tos is not used often.
May be we just need to restore the missing 'tos &= IPTOS_RT_MASK;'
line?
Regards
--
Julian Anastasov <j...@ssi.bg>
