On Thu, Apr 21, 2016 at 02:48:42PM +0530, Pramod Kumar wrote:
> Adding binding doc for ethernet master present in shared
> MDIO controller.
>
> Signed-off-by: Pramod Kumar <pramod.ku...@broadcom.com>
> Reviewed-by: Ray Jui <ray....@broadcom.com>
> Reviewed-by: Scott Branden <scott.bran...@broadcom.com>
> ---
> .../bindings/net/brcm,iproc-mdio-shared.txt | 32
> ++++++++++++++++++++++
> 1 file changed, 32 insertions(+)
> create mode 100644
> Documentation/devicetree/bindings/net/brcm,iproc-mdio-shared.txt
>
> diff --git a/Documentation/devicetree/bindings/net/brcm,iproc-mdio-shared.txt
> b/Documentation/devicetree/bindings/net/brcm,iproc-mdio-shared.txt
> new file mode 100644
> index 0000000..1ffdd4b
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/brcm,iproc-mdio-shared.txt
> @@ -0,0 +1,32 @@
> +Broadcom Ethernet master for shared mdio controller
> +
> +Required properties:
> +- compatible: must be "brcm,iproc-mdio-master-eth"
> +- reg: master id of Ethernet block
> +- address-cells: should be 1
> +- size-cells: should be 0
> +
> +Sub-nodes:
> + Each port's PHY should be represented as a sub-node.
> +
> +Sub-nodes required properties:
> +- reg: the PHY number
> +- phy-mode: media type connecting the PHY and MAC.
> +
> +
> +Example:
> + eth-master@0 {
Is this a child of something?
Why is this not just an mdio bus underneath the ethernet controller? How
is this accessed?
> + compatible = "brcm,iproc-mdio-master-eth";
> + reg = <0x0>;
> + #address-cells = <1>;
> + #size-cells = <0>;
> + gphy0: eth-phy@10 {
> + reg = <0x10>;
> + phy-mode = "mii";
> + };
> + status = "ok"
> + };
> +
> +For more info on ethernet phy binding, please,refer to:
> +Documentation/devicetree/bindings/net/phy.txt
> +Documentation/devicetree/bindings/net/ethernet.txt
> --
> 1.9.1
>
