On Sat, Apr 09, 2016 at 01:22:47AM +0300, Sergei Shtylyov wrote:
> The PHY devices sometimes do have their reset signal (maybe even power
> supply?) tied to some GPIO and sometimes it also does happen that a boot
> loader does not leave it deasserted. So far this issue has been attacked
> from (as I believe) a wrong angle: by teaching the MAC driver to manipulate
> the GPIO in question; that solution, when applied to the device trees,
> led to adding the PHY reset GPIO properties to the MAC device node, with
> one exception: Cadence MACB driver which could handle the "reset-gpios"
> prop in a PHY device subnode. I believe that the correct approach is to
> teach the 'phylib' to get the MDIO device reset GPIO from the device tree
> node corresponding to this device -- which this patch is doing...
>
> Note that I had to modify the AT803x PHY driver as it would stop working
> otherwise as it made use of the reset GPIO for its own purposes...
Lots of double spaces in here. Please fix.
>
> Signed-off-by: Sergei Shtylyov <sergei.shtyl...@cogentembedded.com>
>
> ---
> Documentation/devicetree/bindings/net/phy.txt | 2 +
> drivers/net/phy/at803x.c | 19 ++------------
> drivers/net/phy/mdio_bus.c | 4 +++
> drivers/net/phy/mdio_device.c | 27 +++++++++++++++++++--
> drivers/net/phy/phy_device.c | 33
> ++++++++++++++++++++++++--
> drivers/of/of_mdio.c | 16 ++++++++++++
> include/linux/mdio.h | 3 ++
> include/linux/phy.h | 5 +++
> 8 files changed, 89 insertions(+), 20 deletions(-)
[...]
> Index: net-next/drivers/of/of_mdio.c
> ===================================================================
> --- net-next.orig/drivers/of/of_mdio.c
> +++ net-next/drivers/of/of_mdio.c
> @@ -44,6 +44,7 @@ static int of_get_phy_id(struct device_n
> static int of_mdiobus_register_phy(struct mii_bus *mdio, struct device_node
> *child,
> u32 addr)
> {
> + struct gpio_desc *gpiod;
> struct phy_device *phy;
> bool is_c45;
> int rc;
> @@ -52,10 +53,17 @@ static int of_mdiobus_register_phy(struc
> is_c45 = of_device_is_compatible(child,
> "ethernet-phy-ieee802.3-c45");
>
> + gpiod = fwnode_get_named_gpiod(&child->fwnode, "reset-gpios");
Calling fwnode_* functions in a DT specific file/function? That doesn't
make sense.
> + /* Deassert the reset signal */
> + if (!IS_ERR(gpiod))
> + gpiod_direction_output(gpiod, 0);
> if (!is_c45 && !of_get_phy_id(child, &phy_id))
> phy = phy_device_create(mdio, addr, phy_id, 0, NULL);
> else
> phy = get_phy_device(mdio, addr, is_c45);
> + /* Assert the reset signal again */
> + if (!IS_ERR(gpiod))
> + gpiod_set_value(gpiod, 1);
> if (IS_ERR_OR_NULL(phy))
> return 1;
>
