On Mon, Jan 23, 2006 at 08:03:15PM +0200, Pekka Pietikainen wrote: > The box is a Nexcom NSA 1086 with 4x skge ports and 4x sky2. acpi=off made > the driver work apparently, haven't used it with much load yet, though. Ran the box for a while with some load (the sky2 ports on the box are only used for sniffing, really, so no outbound traffic), and after a while the box stopped receiving traffic on one of the interfaces (the one with the most traffic). Tried rmmod/modprobe sky2, that didn't help as well as disabling rx checksums with ethtool.
Jan 24 11:06:45 localhost kernel: sky2 eth4: enabling interface Jan 24 11:06:46 localhost kernel: sky2 eth3: Link is up at 100 Mbps, full duplex, flow control none Jan 24 11:06:46 localhost kernel: sky2 eth4: Link is up at 100 Mbps, full duplex, flow control none Jan 24 11:06:48 localhost kernel: sky2 eth1: enabling interface Jan 24 11:06:48 localhost kernel: sky2 eth2: enabling interface Jan 24 11:41:30 localhost kernel: sky2 eth3: rx error, status 0x7ffc2001 length 1112 Jan 24 12:05:10 localhost kernel: sky2 eth3: disabling interface Jan 24 12:05:12 localhost kernel: sky2 eth3: enabling interface Jan 24 12:05:12 localhost kernel: sky2 unknown status opcode 0xe3 Jan 24 12:05:12 localhost kernel: sky2 eth3: rx error, status 0x9f6c1703 length 58049 Jan 24 12:05:14 localhost kernel: sky2 eth3: Link is up at 100 Mbps, full duplex, flow control none - To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html
