Other than it completes the DDoS.
----- Mike Hammett Intelligent Computing Solutions http://www.ics-il.com Midwest-IX http://www.midwest-ix.com ----- Original Message ----- From: Zach Puls <zp...@ksfiber.net> To: Mike Hammett <na...@ics-il.net> Cc: 'nanog list' <nanog@nanog.org> Sent: Tue, 06 Nov 2018 13:55:22 -0600 (CST) Subject: RE: Switch with high ACL capacity Wouldn’t it be more beneficial to just have a low-cost system for detection, then trigger an RTBH community advertisement to your upstream(s)? Zach Puls Network Engineer | MEF-CECP KsFiberNet -----Original Message----- From: NANOG <nanog-bounces+zpuls=ksfiber....@nanog.org> On Behalf Of Mike Hammett Sent: Tuesday, November 06, 2018 13:47 To: Lotia, Pratik M <pratik.lo...@charter.com> Cc: 'nanog list' <nanog@nanog.org> Subject: Re: Switch with high ACL capacity The intent is to see if I can construct a poor man's DDOS scrubber. There are low cost systems out there for the detection, but they just trigger something else to do the work. Obviously there is black hole routing, but I'm looking for something with a bit more finesse. If I need to get a switch anyway, might as well try to take advantage of it for other uses. -----Mike HammettIntelligent Computing SolutionsMidwest Internet ExchangeThe Brothers WISP ----- Original Message ----- From: Lotia, Pratik M <pratik.lo...@charter.com> To: Mike Hammett <na...@ics-il.net>, 'nanog list' <nanog@nanog.org> Sent: Tue, 06 Nov 2018 12:29:15 -0600 (CST) Subject: Re: Switch with high ACL capacity Mike, Can you shed some light on the use case? Looks like you are confusing ACLs and BGP Flowspec. ACLs and Flowspec rules are similar in some ways but they have a different use case. ACLs cannot be configured using Flowspec announcements. Flowspec can be loosely explained as 'Routing based on L4 rules' (there's a lot more to it than just L4). I doubt if a there is a Switch which can hold a large number of Flowspec entries. ~Pratik Lotia “Improvement begins with I.” On 11/6/18, 10:39, "NANOG on behalf of Mike Hammett" <nanog-boun...@nanog.org on behalf of na...@ics-il.net> wrote: I am looking for recommendations as to a 10G or 40G switch that has the ability to hold a large number of entries in ACLs. Preferred if I can get them there via the BGP flow spec, but some sort of API or even just brute force on the console would be good enough. Used or even end of life is fine. -----Mike HammettIntelligent Computing SolutionsMidwest Internet ExchangeThe Brothers WISP E-MAIL CONFIDENTIALITY NOTICE: The contents of this e-mail message and any attachments are intended solely for the addressee(s) and may contain confidential and/or legally privileged information. If you are not the intended recipient of this message or if this message has been addressed to you in error, please immediately alert the sender by reply e-mail and then delete this message and any attachments. If you are not the intended recipient, you are notified that any use, dissemination, distribution, copying, or storage of this message or any attachment is strictly prohibited.
