Do you need full routes? What about just a default route from BGP? Erich Kaiser The Fusion Network er...@gotfusion.net Office: 815-570-3101
On Tue, May 15, 2018 at 5:38 PM, Aaron Gould <aar...@gvtc.com> wrote: > You sure it doesn't have something to do with 60 seconds * 3 = 180 secs of > BGP neighbor Time out before it believes neighbor is dead and remove routes > to that neighbor? > > Aaron > > > On May 15, 2018, at 9:10 AM, Adam Kajtar <akaj...@wadsworthcity.org> > wrote: > > > > Hello: > > > > I'm running two Juniper MX104s. Each MX has 1 ISP connected running > > BGP(full routes). iBGP is running between the routers via a two port 20G > > lag. When one of the ISPs fails, it can take upwards of 2 minutes for > > traffic to start flowing correctly. The router has the correct route in > the > > routing table, but it doesn't install it in the forwarding table for the > > full two mins. > > > > I have a few questions if anyone could answer them. > > > > - What would a usual convergence time be for this setup? > > - Is there anything I could do speed this process up? (I tried > Multipath) > > - Any tips and tricks would be much appreciated > > > > Thanks in Advance > > -- > > Adam Kajtar > > Systems Administrator > > City of Wadsworth > > akaj...@wadsworthcity.org > > ----------------------------------------------------- > > http://www.wadsworthcity.com > > > > Facebook <http://www.facebook.com/cityofwadsworth>* |* Twitter > > <https://twitter.com/CityOfWadsworth> *|* Instagram > > <https://www.instagram.com/cityofwadsworth/> *|* YouTube > > <https://www.youtube.com/channel/UCymlH-AZgvxTaHtgp3-AmDQ> > >
