We use a mix of software and hardware based routers, have found little
difference between the two platforms in terms of performance and
stability. Our software base routers are serving a couple 100Mbps
upstream links running on some HP Proliants with dual PS and dual HD's
that we picked up on ebay for a $150 then loaded Quagga on them.
I actually have to give a little bit of a edge to the Linux based
systems only because of all the all the other wealth of
diagnostics/troubleshooting tools one gets with Linux in general...Its
nice to be able to run Wireshark right on the systems if we need too.
As for troubleshooting, I've found the Quagga mailing list to be just as
responsive (if not more responsive at times) as Cisco, but clearly your
mileage will vary there.
Bret
On 09/27/2010 04:59 PM, Dylan Ebner wrote:
We have looked at using open source routers for our border, but in the end we
cannot make the numbers add up. Once Cisco released the x9xx ISR2 routers, the
x8xx have tanked in price on the used market. So, for about the same as a
vyatta router running on newer hardware that you can trust you can get a 28xx
or 38xx. If you also want support, Cisco will support these at less than
$100/month and that gets you access to the IOS upgrades and a 4 hr. replacement
window. I know I sleep better knowing Cisco will drop off a router in less than
4 hours if one of mine fails.
Dylan
-----Original Message-----
From: Nathanael C. Cariaga [mailto:nccari...@stluke.com.ph]
Sent: Sunday, September 26, 2010 4:42 AM
To: nanog@nanog.org
Subject: Software-based Border Router
Hi All!
Just want to ask if anyone here had experience deploying software-based routers
to serve as perimeter / border router? How does it gauge with hardware-based
routers? Any past experiences will be very much appreciated.
I wanted to know because we've been asked if we want to assume full control of
the internet link (up to the router). By assuming control up to the router, we
still want to configure iBGP with our parent network so that we can take
advantage of some routes available to the parent network's gateway. The saddest
part is presently we do not have the router to serve as our gateway this is why
we are considering the use of software-based routers.
Thank you.
