> > Run mythtvsetup then choose Input --> Select input connection --> > > change Starting channel in the setup page. > > The problem with this is that it gets reset each time you change the > channel to the currently tuned one. >
As my original positing said, i've already tried this and it doesn't appear to make a difference to the channel that's tuned when the card is idle. This setting only seems to affect which channel is tuned on next entry to livetv. > This seems to be related to the "channel crawling" feature that's been > muted, i.e the DVB code would when mythtv was idle tune to each of the > channels and attempt to update the EPG. > > However it's not bubbled to the top of the list yet. Indeed it does seem related, although i'm only looking for the basic functionality of being able to specify a single channel that will be used when the card is idle. I think the consensus seems to be that this currently requires a manual database tweak rather than being configurable through any GUI (would be nuice if you could confirm this, I was half expecting to need to change a hard-coded value in the source). If there is a work-around then i'll happily use that until the "channel crawling" functionality becomes a reality. Steve p.s. a big thank-you to all the DVB devs, the improvements since I started using mythtv (0.14) have been highly appreciated! _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
