On Wed, Jan 30, 2002 at 10:54:24AM -0500, Bechtold, Katie wrote: > I'm trying to install mutt on a Slackware 7.0 system, but I'm stuck on the > configure step. I get the following error: > > checking whether this iconv is good enough... no > configure: error: Try using libiconv instead > > I just installed libiconv-1.7, but I see that's not enough to make configure > see it. What do I have to do to "use" libiconv?
Very likely you still have the old config.status sitting around. After having properly installed libiconv, do a 'make distclean'. Then start over with 'configure', etc. Hope this helps. - Myrddin ------------------------------------------------------------------------------ ICQ: 22404528 Why Vegan? http://www.firstmagic.com/vegan ------------------------------------------------------------------------------
