> Everything looks good there - I see you specified the bitrate > as 1800 (user rate VCD) at this stage but omitted it from the mplex > run below > > For user specified VCD (-f 2 or 5) it is necessary to specify the > bitrate (as was done for mpeg2enc). Add the video and audio rates, > and then a ~2% overhead factor.
In the mplex output, I see that both audio and video bitrates are detected correctly. Specifying with -r on the command line didn't help, unfortunately. > it might also be necessary to specify the video buffer size. For > normal VCD that is 46 but for higher rates raising that might be > needed. I will try this one as well, thanks for your help! Regards, Hans ------------------------------------------------------- This SF.net email is sponsored by: Perforce Software. Perforce is the Fast Software Configuration Management System offering advanced branching capabilities and atomic changes on 50+ platforms. Free Eval! http://www.perforce.com/perforce/loadprog.html _______________________________________________ Mjpeg-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/mjpeg-users
